LIQUID APPLICATION INSTRUCTIONS FOR A MOUSING
SURFACE
1. Clean surface to remove any oils, debris, and dirt.
Let dry.
2. Shake LIQUID well and place a small puddle
(approximately the size of a dime for a surface size
up to 10"x10") in middle of surface and wipe around
evenly in circles with a lint free sponge (included)
or cloth. Very little is needed to reduce friction,
therefore do not over-apply LIQUID as it can fill in
textured surfaces.
3. Surface may be used immediately once dry (within
minutes after treatment.) Full cure treatments are
more durable. Full cure is 24 hours.
4. A blow dryer may be used to "cure" LIQUID more
quickly on pads and feet.
5. Re-treat as needed (depending on use can be
approximately once per week up to once per month)
LIQUID APPLICATION INSTRUCTIONS FOR MOUSE FEET
1. Clean mouse feet by wiping off any debris and
buildup.
2. Isopropyl alcohol can be used if heavy cleaning is
needed. If a Teflon tape product has been used on the
feet, all glues MUST be removed for proper `slickness'
to be achieved.
3. Turn mouse upside down and support it so it stays
level.
4. Shake LIQUID well and place small amount on each
mouse `foot'. Allowing for a level coating over entire
mouse `foot'.
5. Using the included sponge, even out the drop on top
of the mouse foot.
6. Let dry before use.
Keep
LIQUID out of the optical eye port if you use an optical
mouse. If contact occurs, wipe LIQUID out immediately.
** As with all household chemicals; keep out of reach of
children and do not ingest** |
